HVAC Installation in Battle Mountain, NV
A new system here will heat from September through May and cool from July through August every year. Tell us about the house, and a licensed contractor who covers Lander County will get in touch.
Tell us about the job
It takes about a minute.
Battle Mountain asks a lot of a new system
Winter nights here average 20°F from December through February, and homes need heat from September through May, nine months of the year. A new furnace has to hold a house warm through that whole stretch, not just get through a cold snap.
Summer only asks two months of work, July and August, with afternoons averaging 85°F. That is a short cooling season next to a long heating one, and it is worth sizing a system for the season that runs nine months rather than the one that runs two. Nevada saw 13% of households lose power for at least a day in 2024, so a new install is also a chance to plan for a furnace that starts back up on its own once power returns, without anyone having to relight it.
- 9 months
- September through May, your system heats
- 2 months
- July through August, it cools
- 20°F
- the average winter night it heats against
- 85°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Nevada requires HVAC contractors to hold a state license.
The license is issued to the contractor, not to the job, so it covers this installation and every other job that contractor takes on. It is issued by the Nevada State Contractors Board.
For an installation like this one, the license is what stands behind the contractor doing the work. In most cities and counties in Nevada, putting in a furnace, air conditioner or heat pump also needs a permit from the local building office, with an inspection once the work is done.
Sources: Nevada Legislature · Nevada State Contractors Board
- When should I replace my HVAC system?
- Replace it when repairs keep coming back or the system can no longer keep the house comfortable. A furnace or air conditioner that breaks down every year, or one that runs constantly without getting the house to temperature, is telling you it's done. Age matters too. Homes here need heat from September through May, so a furnace that struggles early in that stretch will only get worse as winter sets in and nights average 20°F. Don't wait for a full breakdown in the middle of that stretch to find out.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, yes, it usually makes sense to replace them together. A furnace and air conditioner installed at the same time age at the same rate, so when one is close to failing the other usually isn't far behind. Replacing them together also means the coil and blower are matched to the new equipment from the start. If only one has failed and the other is still young, a contractor can tell you whether it's worth pairing them or replacing just the one that's failed.
- What happens during an HVAC installation?
- A contractor removes the old furnace and air conditioner, sets the new equipment in place, and connects it to the existing ducts, gas line, and electrical. The refrigerant lines get connected and the system is charged, then tested to check airflow, temperature, and that everything is running correctly. In most cities and counties this work needs a permit from the local building office and an inspection once it's done. That inspection is there to confirm the job was done to code, so it's worth asking your contractor how they handle it.