HVAC Repair in Caliente, NV
Homes here need heat from October through May and cooling from June through September. If your system quits, tell us what it's doing and a licensed contractor who covers Lincoln County will get in touch.
Tell us about the job
It takes about a minute.
Caliente asks for heat or cooling every month of the year
Your furnace runs October through May here, eight months, with winter nights averaging 27°F. That means long stretches where the burner is cycling on and off through the coldest part of the night, and every start puts wear on the igniter. When it finally gives out, the burner won't light at all and the house goes cold fast.
Summer is shorter but harder on the system, four months of afternoons near 90°F pushing your air conditioner to run long cycles to keep up. The compressor and the fan motor take the brunt of that heat. Lincoln County has also seen 30 damaging wind events and 7 winter storms over the past ten years, and a power outage at the wrong hour can shut a system down right when the temperature is doing the most to your house.
- 8 months
- October through May, your system heats
- 4 months
- June through September, it cools
- 27°F
- the average winter night it heats against
- 90°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Nevada requires HVAC contractors to hold a state license.
The Nevada State Contractors Board tests and licenses the contractor, not the individual repair. Once someone earns that license, it stays on record with the board under their name and their business, not tied to any single job.
For a repair to your heating and cooling system, that license is what stands behind the person doing the work. Nevada checked who they are before they ever knocked on your door, and the board keeps that record on file for as long as they hold the license.
Sources: Nevada Legislature · Nevada State Contractors Board
- Why is my heat not working?
- The most common reason is the igniter or the flame sensor. Gas furnaces have to prove a flame within seconds of startup, and if the igniter won't light or the flame sensor can't detect it, the system shuts itself down rather than run unsafely. A dirty flame sensor is often the cause and can sometimes be cleaned, but a weak igniter usually needs replacing. If your thermostat screen is blank or your furnace won't even turn on, check your breaker panel first. With winter nights here averaging 27°F, a furnace that keeps shutting down is worth getting looked at quickly.
- Why is my system running but not cooling the house?
- If air is moving but it isn't cold, the problem is usually low refrigerant from a leak, or a coil that's frozen over and blocking airflow. A frozen coil often means airflow was restricted somewhere first, commonly a dirty filter, so that's worth checking before anything else. If the outdoor unit isn't running at all while the indoor blower is, the compressor or the capacitor that starts it may have failed. On a 90°F afternoon a system that's only moving air is not doing its job, and refrigerant leaks don't fix themselves, so this is a repair worth calling in rather than waiting out.
- What can I check before calling for HVAC repair?
- Start with the thermostat. Make sure it's set to heat or cool as needed and that the batteries aren't dead, since a thermostat that's lost power will stop calling for either. Next check the air filter, since a clogged one restricts airflow enough to cause a frozen coil in summer or a furnace that overheats and shuts off in winter. Then check the breaker panel and, for gas furnaces, that the gas valve is open. If everything there looks fine and the system still isn't heating or cooling, a licensed contractor will need to diagnose it, since Nevada requires an HVAC contractor's license for this kind of repair work.