Furnace Repair in Carson City, NV
Furnaces here run from October through May. If yours quits, tell us what it's doing and a licensed contractor who covers Carson City will get in touch.
Tell us about the job
It takes about a minute.
Eight months of heat, and cold nights to match
Carson City needs the furnace running from October through May. That is eight months out of the year, and on winter nights that average 25°F, the burner is cycling on and off for hours at a stretch. Every start puts load on the igniter and the flame sensor, and over enough winters one of them gives out.
Most homes here heat with gas, so when the power goes out the furnace stops even if the gas is still on. The blower and controls need electricity to run. Nevada saw 13% of households lose power for a full day or more in 2024, and this area has logged 221 winter storms and 287 damaging wind events over the past ten years. A furnace that was working fine can go quiet the moment the lights do, and it needs a reset or a check before it will run again.
- 8 months
- October through May, your furnace is on duty
- 25°F
- the average winter night it heats against
- 76%
- of homes here heat with gas, so most furnaces here burn gas
- 221 winter storms
- in ten years, the nights a failure hurts most
NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $130 a year off heating for a typical Carson City home.
Estimates for a typical Carson City home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Nevada fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
Nevada requires HVAC contractors to hold a state license.
The Nevada State Contractors Board tests contractors before it licenses them, and it keeps a record of who holds that license. The license belongs to the contractor, not to any single job, so the same license that covers a furnace repair in Carson City covers the next job they take on elsewhere in the state.
For a furnace repair, that license is what stands behind the work. Most homes in Carson City heat with gas, and a furnace repair means someone working on a gas connection, which is the part of the job that has to be done right. In Nevada, the license is what says the person doing that work was tested and is on record with the state.
Sources: Nevada Legislature · Nevada State Contractors Board
- Why won't my furnace turn on?
- Most often the thermostat isn't calling for heat, the power is interrupted, or the igniter has failed. Start with the thermostat. Make sure it's set to heat and check the batteries if it uses them. If that's fine, check your breaker panel, since a tripped breaker will shut the whole system down. Gas furnaces also won't fire if the igniter isn't working, or if a safety switch has shut things off because of a problem elsewhere in the system. A licensed contractor can trace it to the actual part.
- Why is my furnace blowing cold air?
- If air is moving but it's not warm, the furnace may be running the blower without the burners lighting. This can happen when the igniter or flame sensor has failed, or when the gas valve isn't opening. It can also mean the thermostat fan is set to "on" instead of "auto", which pushes air through the ducts even between heating cycles. A dirty filter can block enough airflow to trip a safety limit and stop the burners while the blower keeps running. Check the fan setting and the filter first, then have a contractor check the burner side if the air stays cold.
- Why won't my furnace pilot light stay lit?
- A pilot that won't stay lit usually means the thermocouple isn't sensing the flame correctly, so it shuts the gas off as a safety measure. It can also mean the pilot orifice is dirty or a draft in the area is blowing the flame out. Sometimes the gas supply itself is inconsistent. This isn't something to keep relighting on your own since it points to a part that needs replacing. A licensed contractor can test the thermocouple and gas valve and replace what's failing.