Water Heater Repair in Dyer, NV
Tell us what your water heater is doing, and a licensed contractor who covers Esmeralda County will get in touch.
Tell us about the job
It takes about a minute.
Dyer winters put your water heater to work
Water heaters here run hard from October through May, with winter nights averaging 24°F from December through February. Cold ground water takes more time and more heat to bring up to temperature, so the burner or element runs longer on every cycle to do it. That extra runtime wears on the thermocouple and heating element sooner than it would somewhere milder.
Esmeralda County also sees its share of winter storms and damaging wind, and power can go out for a day or more when one hits. Most tanks come back on their own once power returns, but a unit that was already struggling before the outage may not recover on its own. If your water isn't getting hot, or it runs out faster than it used to, that's often the tank telling you it's been working harder than it should.
- 24°F
- the average winter night, and colder incoming water means longer heating
- 8 months
- October through May, the months homes here need heat
- 13%
- of Nevada households lost power for a day or more in 2024, and a heater with an electric element or electric ignition stops without it
NOAA nClimDiv, 1991–2020 normals
- Why is my water heater leaking from the bottom?
- The most common reason is that the tank itself has corroded through and is failing. Sediment builds up on the bottom of the tank over years, and the steel underneath it rusts out from under that layer. A leak from the bottom almost always means the tank needs to be replaced, not repaired, since there is no way to patch a hole in the steel. Sometimes what looks like a bottom leak is actually water dripping down from a loose fitting or the drain valve higher up, so it is worth checking those first before assuming the tank is gone.
- Why won't the pilot light on my water heater stay lit?
- Most often the thermocouple has worn out and stopped sensing that the flame is lit, so the gas valve shuts off the pilot as a safety measure. A dirty or clogged pilot orifice can cause the same thing by starving the flame. Less often, a draft from a nearby vent or window is blowing the pilot out before the thermocouple even gets a chance to react. A contractor can test the thermocouple and clean or replace the parts that are keeping the flame from holding.
- Can a tankless water heater be repaired?
- Yes, most problems in a tankless unit can be fixed without replacing the whole thing. Mineral buildup on the heat exchanger is the most common issue, and it's cleared with a descaling flush. Igniter failures, sensor faults, and venting blockages are also things a contractor can diagnose and repair. Replacement usually only comes up when the heat exchanger itself has cracked or corroded through.