Nevada HVAC Pros
A bare branch covered in dripping icicles photographed during a winter ice storm, with snow-covered shrubs and a house visible in the background.

HVAC Installation in Hawthorne, NV

A new system here will heat from October through May and cool from July through August every year. Tell us about the house, and a licensed contractor who covers Mineral County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An unfinished basement containing a gas furnace with ductwork in the foreground and miscellaneous stored items along the far concrete wall.

Ten months of the year, your system is working

Hawthorne needs heat from October through May and cooling in July and August. That is ten months where a furnace or AC that fails leaves you stuck. Winter nights average 22°F, cold enough that a new furnace needs to hold up to months of hard use, not just the occasional freeze. Summer afternoons average 86°F, so the cooling side has real work to do too, even in a short season.

Nearly half the homes here heat with propane, which means the furnace and the fuel line it runs on both matter when you install. Mineral County has seen 17 winter storms and 61 damaging wind events over the past ten years, and across Nevada, 13% of households lost power for at least 24 hours in 2024. A new system should be matched to a heat source and setup that keeps working when the weather turns hard.

8 months
October through May, your system heats
2 months
July through August, it cools
22°F
the average winter night it heats against
86°F
the average summer afternoon it cools against
Isometric grayscale illustration of a cutaway house showing an interior furnace with a tall flue pipe and ductwork running to rooms under a partially lifted roof.
Your system heats October through May and cools July through August.

NOAA nClimDiv, 1991–2020 normals

Nevada requires HVAC contractors to hold a state license.

The Nevada State Contractors Board tests contractors before they get a license and keeps a record of who holds one. That license belongs to the contractor, not to any single job, so it stands behind every installation they do, not just this one.

For this job, that license is what stands behind the person doing the work. On top of it, most cities and counties require a permit before a furnace, air conditioner or heat pump goes in, and an inspection once it is done. That inspection checks the installation itself, separate from whatever the state license already covers.

Sources: Nevada Legislature · Nevada State Contractors Board

When should I replace my HVAC system?
Once your system needs repairs almost every year, or it can no longer keep the house comfortable, it is time to start pricing a replacement. Age matters too. A furnace or air conditioner working hard past its expected life is more likely to fail on the coldest night or the hottest afternoon, and here that means a 22°F night or an 86°F day with no relief until someone can get to it. Rising energy bills without any other explanation are also a sign the equipment is losing efficiency. A contractor can look at the actual unit and tell you whether repair or replacement makes more sense for your house.
Should I replace my furnace and air conditioner at the same time?
If both are original to the house and close in age, replacing them together is often worth considering, since a furnace and air conditioner installed years apart may not be sized or matched to work well as a pair. It also means one visit and one inspection instead of two, which matters less for cost and more for keeping the work straightforward. That said, if one unit is much newer than the other, there is no reason to replace something that still has years left in it. A contractor can check both and tell you whether they should go together or separately.
What happens during an HVAC installation?
A contractor first removes the old furnace, air conditioner or heat pump and disconnects it from the ductwork, gas line, refrigerant lines and electrical. The new equipment goes in, gets connected to those same systems, and is checked for gas or refrigerant leaks before it is sealed up. Once it is running, the contractor tests it through a full cycle to confirm it heats or cools properly and that the thermostat controls it the way it should. In most cities and counties this work needs a permit from the local building office, and an inspector checks it once the job is done.